Type of Presentation	Style of presentation	Abstract Deadline	Presentation video upload deadline	JJAP Special Issue deadline	Additional request (for MNC web site)
Plenary Talk	45 min. Talk Talk on site (40 min.)+ Q&A (5 min.)	Abstract Until August 31		Special Issue November 30 Progress Review	Short Biography Photo
Keynote Talk	On-demand (Only Video File) from 45 min. to 90 min. Talk	Abstract Until August 31	Video File (MP4) Until September 30	Special Issue November 30 Progress Review	Short Biography Photo
Invited Talk	30 min. Talk Talk on site (25 min.)+ Q&A (5 min.)	Abstract Until August 31		Special Issue November 30 Progress Review	Short Biography Photo
Invited Talk (Symp. A)	30 min. Talk Talk on site (25 min.)+ Q&A (5 min.) Talk online (25 min.)+ online Q&A (5 min.)	Abstract Until August 31	Video File (MP4) Until September 30	Special Issue November 30 Progress Review	Short Biography Photo
Regular Oral Talk	20 min. Talk Talk on site (15 min.)+ Q&A (5 min.)	Abstract Until from July 1 to July 10		Special Issue November 30 Regular Paper
Regular Poster Presentation	2 hour on site	Abstract Until from July 1 to July 10 Until September 1		Special Issue November 30 Regular Paper
Regular Poster Presentation of Symp. A	2 hour on site		Short presentation video File (max 10 min.) of your poster (MP4) Until September 30	Special Issue November 30 Regular Paper

Please submit 1 or 2 page of abstract through MNC 2022 web site until July 10, 2022 (Extended Deadline for Submission of Abstract from July 1). Notice of accept or reject will be sent to you at around the end of August. Please send us your authors confirmation through MNC 2022 web site. Please submit full paper in MNC special issue through JJAP web site until November 30. (It is not mandatory, but your contributions are cordially welcome.) July 1, 2022.
1. INTRODUCTION
This describes instructions for the preparation of a PDF abstract. Prospective authors are encouraged to submit a 2-page abstract.The abstract must clearly state the purpose, achievement and significance of the work. Please note that the most common cause of rejection of submitted papers is a lack of specific results, e.g. figures and tables, and of the description on experimental/theoretical procedures. The abstract must be prepared following the guideline. The abstracts are published as the web conference site, which will be available for registrants at the conference.
2. TYPING
The abstract should be neatly typed on A4-size. Type the title on the first line, authors’ full name(s) on the third line and addresses on the fourth line. Title, author(s) and address(es) should be typed centered. Begin the texts two lines below the last line of the title/author section. The second page should be used for indicating figures, tables and photographs. Caption should be typed underneath the figure and above the table.Additional typing guidelines are summarized in Table 1.Sectioning is not always required and is optional.
Sample Abstract (2005 International Microprocesses and Nanotechnology Conference Digest Papers, Page 136-137H. Shimauchi, Y. Ohno, S. Kishimoto and T. Mizutani, Nagoya University, JapanCopyright, Since 2005 JSAP, All right reserved) mnc_sample_abstract Abstract Template.docx abstract_template_mnc2022
3. SUBMISSION
Submit the abstract in a PDF format Table1. Typing Guidelines for the abstract PDF File: Please avoid setting up user password and master password in the PDF file. A PDF file must be smaller than 3MByte.Line spacing: single-spaced.Format: An A4-size or a 21.6 cm x 28 cm is preferable. The first page must include the title of the paper, author(s), affiliation(s), address, e-mail address, and article text.Font Size: 11 – 12 point font is recommended for text.Character: Times-Fonts Family and Helvetica-Fonts Family are recommended. DO NOT use two byte characters and Asian Fonts, e.g., Japanese, Korean, and Chinese characters, MS Gothic, MS Mincho, Ryumin, Batang etc.