MNC 2010, 23rd International Microprocesses and Nanotechnology Conference
November 9-12, 2010
, Rihga Royal Hotel Kokura, Fukuoka, Japan





MNC 2010 Program (817KB)
inculuding Tentative Time Schedule (August 12)
MNC 2010 Session Schedule.html
MNC 2010 Oral Instruction
MNC 2010 Poster Session Instruction
Papers will be published online on October 26, 2010.

Late News Paper Deadline: September 15, 2010

Extended Deadline: July 6, 2010
https://www.i-product.biz/mnc2010/regist/index.html


Deadline: June 30, 2010

1. INTRODUCTION
  This describes instructions for the preparation of a camera-ready abstract. Prospective authors are encouraged to submit a 2-page abstract. The abstract must clearly state the purpose, achievement and significance of the work. Please note that the most common cause of rejection of submitted papers is a lack of specific results, e.g. figures and tables, and of the description on experimental /theoretical procedures. The abstract must be prepared following the instruction because it is printed by the photo-offset method. The abstracts are published as the Digest of papers, which will be available for registrants at the conference.
2. TYPING
  The abstract should be neatly typed on A4-size or US letter size (8.5 inches x  11 inches) plain white sheets. Type the title on the first line, authors’name(s) on the third line and addresses on the fourth line. Title, author(s) and address(es) should be typed centered. Begin the texts two lines below the last line of the title/author section. The second page should be used for indicating figures, tables and photographs. Caption should be typed underneath the figure and above the table.
 Additional typing guidelines are summarized in Table 1. 
 Sectioning is not always required and is optional.
 An example of the abstract is found in ABSTRACT.EXAMPLE.
3. SUBMISSION
 Submit the abstract in a PDF format with the copyright form.

Table1. Typing Guidelines for the abstract
-----------------------------------------------------------------------------------------------------------------------------------------
PDF File: Please avoid setting up user password and master password in the PDF files. A PDF file must be smaller than 3MByte.
Line spacing: single-spaced.
Format: An A4-size or a 21.6cm×28cm is preferable. The first page must include the title of the paper, author(s), affiliation(s), address, e-mail address, and article text.
Font Size: 11 - 12 point font is recommended for text.
Character: Times-Fonts Family and Helvetica-Fonts Family are recommended As for Symbolic Characters such as (a) (m), please use Symbol-Fonts Family. DO NOT use two byte characters and Asian Fonts, e.g., Japanese, Korean, and Chinese characters, MS Gothic, MS Mincho, Ryumin, Batang etc.
------------------------------------------------------------------------------------------------------------------------------------------
* ABSTRACT.EXAMPLE:
2005 International Microprocesses and Nanotechnology Conference Digest Papers, Page 136-137
H. Shimauchi, Y. Ohno, S. Kishimoto and T. Mizutani, Nagoya University, Japan
Copyright, Since 2005 JSAP, All right reserved
* Copyright form.doc
* for under 33 years old, young authors travel assistance application form





Submission of manuscript to the JJAP

Submission of manuscript to the JJAP

Authors are commended to submit a manuscript of your paper
to the Japanese Journal of Applied Physics (JJAP) by
November 30, 2010.

Strict adherence to this deadline would be helpful for publication on schedule. Manuscripts will be reviewed using standard JJAP procedures and published in the special issue of JJAP as the proceeding of MNC 2010. The JJAP Editorial Board requests authors to note that the manuscript should not be identical with the text of the abstract submitted nor any papers published elsewhere. The content of the manuscript should be original by including additional data and/or further discussion. The best paper award will be selected from papers in the proceedings. When you send your manuscript to JJAP, please be sure the program number of your paper on the JJAP application form. For more information on the preparation of a manuscript, see the JJAP web site.
http://jjap.ipap.jp/special/index.html

Authors who wish to submit a manuscript to the JJAP Special Issue of MNC 2010 are requested to send the application form including agreements with your signatures for copyright transfer and for payment of publication charge of your article accompanied with
 *Computer file of the manuscript in PDF format

(Please prepare the electronic form of the manuscript as one PDF file with text, figures and tables.)
to
=== In the case of Web submission=== 

It is possible to submit your manuscript for MNC special issue of JJAP via following web site from first of September to November 30.
http://www.ipap.jp/jjap/special/ESubmissionSIssue.html

https://solution.dynacom.jp/cgi-bin/ipap/submission/submission.cgi?si=027  (Japanese)
https://solution.dynacom.jp/cgi-bin/ipap/submission/submission.cgi?ln=en&si=027 (English)

<<Publication Charge>>
Please confirm following web site.
http://jjap.ipap.jp/special/index.htm


Copyright(c) Since 2010, 23rd International Microprocesses and Nanotechnology Conference, All Rights Reserved.