Program(update: August 21)

Session Schedule(update: August 21)

Oral Instruction (update: October 10)

Poster Instruction (update: October 10)

Deadline:July 1, 2013 July 7, 2013

Late News Papepr Deadline: September 15, 2013

Prospective authors are requested to submit 2 pages abstract and following question's reply by an e-mail with a PDF (within 3MB) file. Copyright Transfer Form is requested to be sent to the secretariat by fax. Copyright Transfer Form can be downloaded from .Copyright form.doc 1 ( )Mr. ( )Ms. ( )Dr. ( )Prof. Speaker's Name (　　　　　　　　　　　 ) 2. Is the speaker 33 years old or younger at the end of conference(November 4, 2013) ? ( )YES ( )NO (Question for Young Author's Award) 3. Paper Title ( 　　　　　　　　　　　　　　　　　) 4. Field of your abstract (Select one) ( ) 1-1: Advanced Photolithography ( ) 1-2: Electron and Ion Beam Technologies ( ) 1-3: Resist and Directed Self-Assembly ( ) 2-1: Nanocarbons ( ) 2-2: Nanodevices ( ) 2-3: Nanofabrication ( ) 2-4: Inorganic Nanomaterials ( ) 2-5: Organic Nanomaterials ( ) 2-6: NanoTool ( ) 3: Nanoimprint, Nanoprint and Rising Lithography ( ) 4: BioMEMS, Lab on a Chip ( ) 5: Microsystem Technology and MEMS * If your late news paper will be accepted, your session will be Poster session.

1. INTRODUCTION   This describes instructions for the preparation of a camera-ready abstract. Prospective authors are encouraged to submit a 2-page abstract. The abstract must clearly state the purpose, achievement and significance of the work. Please note that the most common cause of rejection of submitted papers is a lack of specific results, e.g. figures and tables, and of the description on experimental　/theoretical procedures. The abstract must be prepared following the instruction because it is printed by the photo-offset method. The abstracts are published as the Digest of papers, which will be available for registrants at the conference. 2. TYPING  　The abstract should be neatly typed on A4-size or US letter size (8.5 inches x  11 inches) plain white sheets. Type the title on the first line, authors’name(s) on the third line and addresses on the fourth line. Title, author(s) and address(es) should be typed centered. Begin the texts two lines below the last line of the title/author section. The second page should be used for indicating figures, tables and photographs. Caption should be typed underneath the figure and above the table. 　Additional typing guidelines are summarized in Table 1.  　Sectioning is not always required and is optional. 　An example of the abstract is found in ABSTRACT.EXAMPLE. 3. SUBMISSION 　Submit the abstract in a PDF format with the copyright form. Table1. Typing Guidelines for the abstract ----------------------------------------------------------------------------------------------------------------------------------------- PDF File: Please avoid setting up user password and master password in the PDF files. A PDF file must be smaller than 3MByte with no security. Line spacing: single-spaced. Format: An A4-size or a 21.6cm×28cm is preferable. The first page must include the title of the paper, author(s), affiliation(s), address, e-mail address, and article text. Font Size: 11 - 12 point font is recommended for text. Character: Times-Fonts Family and Helvetica-Fonts Family are recommended As for Symbolic Characters such as (a) (m), please use Symbol-Fonts Family. DO NOT use two byte characters and Asian Fonts, e.g., Japanese, Korean, and Chinese characters, MS Gothic, MS Mincho, Ryumin, Batang etc. ------------------------------------------------------------------------------------------------------------------------------------------ * ABSTRACT.EXAMPLE: 2005 International Microprocesses and Nanotechnology Conference Digest Papers, Page 136-137 H. Shimauchi, Y. Ohno, S. Kishimoto and T. Mizutani, Nagoya University, Japan Copyright, Since 2005 JSAP, All right reserved * Copyright form.doc * Young TAuthors Application form In MNC2013, Young Author's Travel Assistance will be provided only to one or two speakers from all applicants. In MNC 2013, It is difficult to support as young author's travel assistance for budget problem. JJAP INSTRUCTION Deadline: November 30, 2013 Submission of manuscript to the JJAP Authors are recommended to submit a manuscript of your paper to the Japanese Journal of Applied Physics (JJAP) by November 30, 2013. Strict adherence to this deadline would be helpful for publication on schedule. Manuscripts will be reviewed using standard JJAP procedures and published in the special issue of JJAP as the proceeding of MNC 2013. The JJAP Editorial Board requests authors to note that the manuscript should not be identical with the text of the abstract submitted nor any papers published elsewhere. The content of the manuscript should be original by including additional data and/or further discussion. The best paper award will be selected from papers in the proceedings. When you send your manuscript to JJAP, please be sure the program number of your paper on the JJAP application form. For more information on the preparation of a manuscript, see the JJAP website. General Infomation http://jjap.jsap.jp/authors/index.html Submission Guideline http://jjap.jsap.jp/authors/submission.html Authors who wish to submit a manuscript to the JJAP Special Issue of MNC 2013 are requested to send the application form including agreements with your signatures for copyright transfer and for payment of publication charge of your article accompanied with *Computer file of the manuscript in PDF format (Please prepare the electronic form of the manuscript as one PDF file with text, figures and tables.) === In the case of Web submission===　 It is possible to submit your manuscript for MNC special issue of JJAP via following web site from September 10 to November 30, 2013. http://jjap.jsap.jp/special/ESubmissionSIssue.html Japanese https://xreview.jsap.jp/cgi-bin/submission/submission.cgi?si=075 English https://xreview.jsap.jp/cgi-bin/submission/submission.cgi?ln=en&si=075 <<Publication Charge>> Please confirm following web site. http://jjap.jsap.jp/authors/index.html