MNC 2016, November 8-11, 2016
29th International Microprocesses and Nanotechnology Conference
ANA Crowne Plaza Kyoto, Kyoto, Japan


Session Equipments
All speakers are required to use an electronic projector. An OHP is not available at the conference. To avoid software matching trouble, you are requested to bring your own PC with you for your presentation.
The connector type of the projector is D-sub (15 pin). A USB connection is not available. Please set up your PC before your session starts.

* We can not revise your submitted abstract after reviewed and can not change your session schedule which was decided on the program committee meeting.
1.To the registration desk.

All participants are requested to register.
Please get your name card and answer simple questionnaire
2. To the session registration desk.

All oral authors are requested to bring author's interview document less than
A4 size, 10 sheet (A cutback of the presentation in Power point etc.)*2
3. To the operator in your session room.

Own personal computer at least 15 minutes before your presentation.
4. Presentation

Regular session is 20 min. including 5 min. discussion.

Invited session is 30 min. including 5 min. discussion.

Young Support
MNC shall bear the cost of domestic transportation and accommodation of 3 "Young Support" people. Program Chair shall select those "Young Support" people from applicants in consideration of various things including the rating of reviewed paper.  

The applicant is 33 years old or younger at the end of the confence (November 11, 2016)
Deadline: August 30, 2016

VISA (for only speaker)
In addition to a valid passport, some foreign nationals are required to obtain a visa, issued by the Japanese Consulate in your country, to enter Japan.
If you have to apply for visa to talk on MNC 2016,  please fill in ''questionair for your visa'' and send it to the secretariat until September 30, 2016.

(It you need an invitation letter, please contact to the secretariat.)
5. To the poster panel for Author's Interview in your session room.(Except Plenary Session)

A 10-minutes Author's Interview will be held after each session. The authors are requested to make complementary discussions with audiences.

Please prepare a set of printed copies of slides used in your presentation.(*2)

Your materials will be posted on a 90-cm-wide x 210-cm-high surface board by an MNC staff and will be returned after the session.
* Note that the Author's Interview is excluded from the Most Impressive Poster Award.
Please inform us of your decision on the attendance from the following until September 1.


Copyright(c) Since 2016, 29th International Microprocesses and Nanotechnology Conference, All Rights Reserved.